Welcome to Club Hot Rod!  The premier site for everything to do with Hot Rod, Customs, Low Riders, Rat Rods, and more. 

  •  » Members from all over the US and the world!
  •  » Help from all over the world for your questions
  •  » Build logs for you and all members
  •  » Blogs
  •  » Image Gallery
  •  » Many thousands of members and hundreds of thousands of posts! 

YES! I want to register an account for free right now!  p.s.: For registered members this ad will NOT show

 

Uncategorized

Entries with no category

  1. ignition problems

    by
    papajoe49
    on 08-04-2015 at 06:04 PM
    Quote Originally Posted by rspears View Post
    Joe, what type of compound are you using between the module and the mounting surface on the distributor?
    I was using a dieletic grease.. did some research and found a silicone based heat sink paste that I am going to try....Not going to give up the fight..
    Categories
    ‎ Uncategorized
    Comments 0 Comments

  2. ignition problems

    by
    papajoe49
    on 07-27-2015 at 10:29 PM
    Quote Originally Posted by papajoe49 View Post
    hey guys its papajoe again. Put a new alternator in and have 14.5 volts going to the battery.took it for a run and it ran great ran it for about a half hour volt meter said 14.5 volts. Started it uo tonight and it fired right off. Went for a drive about 15 minutes into it slowly shut down started coughing and quit don't know where to go put a brand new module in yesterday...Take any help I can get. its a 350sb mild cam bare bones..DUI dist. New everything..Cant seem to get a handle on it!!!!!
    Categories
    ‎ Uncategorized
    Comments 0 Comments
Links monetized by VigLink