I'm about to pull the motor from my '94 GMC Truck (5.7L 350 TBI) and attempt my first rebuild...so I have a few questions.

1) Is there a good "rebuild kit" with everything I'll need for the rebuild? I'm planning on stripping it down, having it cleaned and machined and then start the assembly. I'm about 95% sure of what I need, but it's that 5% that has me guessing.

2) What "specialty tools" will I need for this job. I've got a good assortment of hand tools and other shop tools (engine puller, engine stand, floor jack, jack stands...blah, blah, blah) but are there any special tools that I'll need, aka ring compressor, etc.?

3) What other parts should I replace? I think everything is good (it isn't running as strong as it used to...I think it's the rings, thus the rebuild). What are the other "while you are in there" parts that need attention?

4) Any tips for this project? Little gremlins that jump up and bite you?

5) Any other websites with information that would help me through this project? http://www.helprebuildingyour94GMCtr...ubicinchV8.com perhaps?


I'll be on this thread asking more stupid questions as this project continues. I'll probably be pulling the motor in a week or two, so I have a little time for research and preparation. Thanks, guys...