Now I want slightly different help. I've seen those under header ignition wires (refered to as high tension leads over here) and want to get them for my ute. I love the clean engine look and hate the sight of any kind of excessive wiring. I've looked at summit racing and jegs, etc. They are very limited in that line of stock. But there real question is, what clips and brackets (kit?) are available to have the wires kept firmly in place away from the hot manifolds. Would still be with those sexy rams horns (woof woof). Hey Bobby Dazzler, where've you've been lately huh? I'm about to start cleaning up the wiring under the dash of my pick up. It's a real mess and is a fireball waiting to happen. I've just secured the battery + cable loom away from the manifolds - found the several layers of insulation had melted through as the loom was hard against the manifolds in 2 locations . Also had to rewire the burnt starter solanoid wire and temp sender wire for the same reason. Looks like a lot of people can throw expensive parts together to make a cool street machine. But time and time again I've seen real ugly and nasty wiring jobs that are just a nightmare to figure out. Being able to do good electrical work is often what seperates the men from the boys. Do you have any ideas on those ignition wires Streets?