Printable View
My current cam is a Comp Cam Hydrolic Roller 230/236 @.05 & .51/.52 lift. This combo puts down about 390 hp at the wheel. I am thinking about maybe going up a size. Crane recommended their HR-306-2s-10. They claim this is designed for stroker motors; @.05 240/248 lift .558/.558 SLA 110 and IC 105. Any input?
what cr do you have? Stroke? Carb? Intake? Heads?
Ooops! I thought I attached my bio. It is there now. Thanks.
with those heads your CR is about 11.2:1, and would handle the next step up cam - although I would want a 106 duration, and lose the Air Gap for a Victor high rise.
I would also swap out those gears for a set of 410's or 488's.
I run the Comp roller 516/535 with almost the same set-up you have in my modified ( with the changes above ) running a 2 speed direct drive tranny & it runs up front
Everything looks good.What I wonder about is how long your tranny will last.Quote:
Originally posted by KJL
My current cam is a Comp Cam Hydrolic Roller 230/236 @.05 & .51/.52 lift. This combo puts down about 390 hp at the wheel. I am thinking about maybe going up a size. Crane recommended their HR-306-2s-10. They claim this is designed for stoker motors; @.05 240/248 lift .558/.558 SLA 100 and IC 105. Any input?
The transmission is a level three from Bowtie Overdrives out of California. It is built to take 500+ Hp and loads of torque. The torque converter feels to loose though. I think a stall around 2600 would work best with a torquey stroker. I just installed the 3.73 rear. I was thinking about 4.11 but was afraid if I did not like the 2004R and put my Turbo400 back in, the car would not be driveable on the highway. I am trying to get a good balance between street and strip.
When you say it looks good, do you mean the current set up or stepping up to the Crane cam?
Thanks for yalls help!!
[QUOTE]Originally posted by KJL
The transmission is a level three from Bowtie Overdrives out of California. It is built to take 500+ Hp and loads of torque. The torque converter feels to loose though. I think a stall around 2600 would work best with a torquey stroker. I just installed the 3.73 rear. I was thinking about 4.11 but was afraid if I did not like the 2004R and put my Turbo400 back in, the car would not be driveable on the highway. I am trying to get a good balance between street and strip.
When you say it looks good, do you mean the current set up or stepping up to the Crane cam?
Thanks for yalls help!! [/QU You would have to go to a higher stall if you went with the other cam and more gear.