Thread: low priced push rods
Results 1 to 3 of 3
Threaded View
-
02-19-2004 02:48 PM #1
low priced push rods
I just measured my pushrods today and realized I need -.100 or 7.700 long rods just on my intake. Im running Crane gold rollers (1.5) on the intake and harland sharpe (1.6) on the exhaust. If I would have had to guess i would of said the 1.6's were going to be the problem, nope.
Anyways, does anybody have any recomondations for were I could get these kinda cheap? I'm not using guide plates but I would still like them hardened (is that needed?). Keep in mind I only need 8, so if anybody ever ran into this same problem and has the other 8 laying around, let me know.
thanks, JC
When I was about six years old, a race car on a trailer went past our house. I thought it was the coolest thing I had EVER seen! And I haven’t been the same since.That was over fifty years ago. ...
How did you get hooked on cars?