Cam Bearings

I had to remove my 327 from my boat some 10 years and put it in storage.

It's a bare block, I had new cam bearings installed when the block was cleaned and cylinders scuffed. The motor only had about 5 hours before it seized - siezed rod bearing.

Are the cam bearings still okay to reuse ? I would have a most difficult time getting the block to a shop to have them replaced. I know it's a simple process to remove and replace but are they okay to leave in. This is a low hp-200 from a Chris Craft boat.

Thanks for any advise
Mike

Use em, no problem:D

just flush them out good the block bearing bores are fully grooved for oil .so you want to make sure there no junk under them so a good wash and blow them out thru the mains