Hi can any one tell me how to find top dead centre on sbc with cyl heads on thanks
Printable View
Hi can any one tell me how to find top dead centre on sbc with cyl heads on thanks
Remove the coil wire, first!! Take out the spark plug for #1 cylinder, put your thumb over the hole, use a remote on the starter or have someone bump the engine over with the key. You'll feel the compression in the cylinder as the piston comes up on the compression stroke. Then, line the timing mark on the balancer up with the tdc mark on on the pointer. Might have to turn the engine by hand to get the mark lined up exactly.
If you don't have a timing pointer on the block, or if you don't trust that it's right you can find exact TDC in six easy steps:
1) Make an indicator from some clear plastic tubing, a jar of light oil (cooking oil, olive oil, whatever) and an old spark plug.
2) Break up an old spark plug and attach a length of clear plastic tubing to it (make it airtight). A hot glue gun can help here, or you can use silicone if you're patient.
3) Remove all the spark plugs.
4) Stick your thumb OVER the #1 cylinder spark plug hole. Rotate the engine until you feel pressure on your thumb. That's the compression stroke, and TDC is at the top of this stroke.
5) Screw the spark plug with plastic tubing attached into #1 cylinder, and insert the other end of the tube into a the jar of light oil. Continue rotating the engine. Bubbles will appear until the piston reaches the top of its travel. When it starts down on the next stroke the bubbles will stop and oil will begin traveling up the tube. Stop at a convenient point and mark the tube. At the same time mark the crank pulley and the engine body at a convenient spot.
6) Rotate the engine backwards and watch the oil recede into the jar. Continue rotating. As the piston continues past tdc and downward it will again suck oil into the tube. Rotate the engine till the oil again reaches the mark you made in Step 5. STOP! Mark the crankshaft pulley where it lines up with the mark you made previously on the engine. You should now have two marks on the crankshaft pulley. The midpoint of these two marks lined up with the mark on the engine is TDC.
That's using your head, an original idea ?
No matter still a good one worth remembering.
I can't claim being the originator - remembered seeing a way to find true TDC without hard physical stops that can cause damage if not used carefully, and went looking for it.Quote:
Originally Posted by pepi
Cosmic performance Roger!!!! I'm always up for learning a new procedure.
Richard
I consider that high praise coming from you, Tech!Quote:
Originally Posted by techinspector1
Roger - might give it a try. I pulled the MSD distributor today to change the rate of advance (slower) and 'lost my way' as far as gear tooth position, didn't have to fuss today plus it started raining for the first time in a month. I've always used the thumb in #1, which works, but, depending on time constraints tomorrow, may just try that bubbler (GC are going to the beach with grand mom and want a ride:D )
Thanks very much for all of the information