Hey forum, I am planning out parts to start building a 408 stroker with a parallel turbocharger set-up, and I was wondering if anybody had any ideas on what would be a good carb for this application.
Printable View
Hey forum, I am planning out parts to start building a 408 stroker with a parallel turbocharger set-up, and I was wondering if anybody had any ideas on what would be a good carb for this application.
hope your using a very good block . carb holley big 4150 would depend on how much steam your planing to make. boy there not much deck between the bores for head gasket not the best plan i would go after it from another angle ??????
Yep--there is that bolt hole that seems to always be cracked at least to one cylinder, sometimes two ways----------plus almost always to the steam hole
http://www.clubhotrod.com/photopost/...6_640x427_.jpg