Ok I scored a 010 block that had been sitting for awhile, it is a 350 made around 1980 I believe the date code is b108. The head numbers are 462624 with 1.72/1.5 valves. I think the combustion chambers are 76cc. I do need to know what kind of compression I would have with flat tops and with dish pistons.

I need advice on how to build this engine for lots of torque, it is going in a 4x4 blazer with a 700r4 tranny.

Here is what I was thinking:

Q-Jet carb (I already have a good one)
Performer intake (I already have one)
rebuild kit from northern auto parts (block will probable have to bored 30 over)
268 adv Xtreme Comp Cam
stock exhaust manifolds with dual exhaust into a single muffler with dual outs, no cats
stock ignition

Any thought would be greatly appreciated!!!

Bill