Thread: clean up pass
Threaded View
-
02-13-2004 10:16 AM #1
clean up pass
I'm hoping someone can help me with this. I would like to make .20 flute cuts in oak and then do about a .01 clean up cut. If I set the depth at .21 with a .20 per pass depth of cut, it cuts 2 passes @ .105 each pass. Is there a way to set it up in one operation so it makes the full .20 pass and then follows with a .01 clean up pass? Right now I'm setting it up as 2 seperate operations. There should be an easier way.
thanks
That's funny about calling out the car models going by, that's one of my early memories sitting on a bus stop bench with my mom enthusiastically calling out the cool cars going by, I was about 4 or 5...
How did you get hooked on cars?