Printable View
Truck is not a daily driver,but would like too take it on a 2hour drive besides hamering it at the drag strip:D The truck (frame)is being built to MY specs, right now.Its a street/strip build.
Ok now , I am going to need a big cubic inch small block?Or ,Is it cheaper to do a big block? :HMMM:
472/500 c.i.d. Cadillac
http://cad500parts.com/
http://www.500cid.com/
the parts for the big small will cost the same. i would run a big block chevy
I like the big block idea too ,and I have a set of close chamber oval heads.I think I can sell these and with a little more cash buy a set of aluminum rectangal port.You think a stroked big block would be ok?468 maybe.I want something that will really rev.Thanks
use them O ports with some work and go to 4 1/4 stroke or 4 3/8 this will give you a496 or511 at a 0.060 bore and spend the money on a roller cam. that you would on the heads it will rpm but the more rpm is just hard on stuff
Sounds good ,let me investigate this a little more.So this cast heads will be fine with a little work then?Do you think siamese bores are neccesary?
no the older big block will take the bore and the o ports will work good .just work on the Tq not on hp and if you drive it will work good i have bulit some of the 489 and 496 and they work good and there is a lot of parts out there that will get the job done and not cost a arm and a leg
I wont quote you on this ,but just too get a idea of cost whats the average 496 cost?Thanks
Is this a good deal?
WE HAVE A SURPLUS OF BBC. 4.250" STROKER CRANKS
(FORGED-STEEL) (4130)
WE WILL GIVE YOU A DEAL @ $375.00 EACH
PLUS SHIPPING INSURANCE OF $15.00
who s crank ? have had some so bad that i sent them back bent and not to speck i have a nice scat 4130 i can sell to you for that but you will have to pay the shipping on it . that is a very good crank it cost me $500 and i know it is good .if you want this crank or any thing for this engine get a hold of me on private message and i will get you a good deal on parts
I don't mind paying a little more for a better part.What do I need for a block.Theres a few different variations of the big block.What should I stay away from?I need a block asap ,I will be ready to set the placement of the engine in the frame.
the quote i gave you was for the old mark 4 block have used the mark 5 and 6 best thing is to do is call me i will give you my number and call me and i will tell you want you need to know. i well give it to you on your private message okQuote:
Originally posted by BigTruckDriver
I don't mind paying a little more for a better part.What do I need for a block.Theres a few different variations of the big block.What should I stay away from?
the crank i have is on ebay my. ebay name is 7567pat and item no is 8024092732 $ 325 you can look at it and my feed back .so you would have $ 50 less in to this crank. if you win it this would help you on the shipping