I know, this is a heavilly asked question, and kind of sad being I have Dyno 2000 ( I have ran the #, come up with 275 HP, just wondering if anyone could run them on a better program ). I have a '67 Ford 200 I6 that I'm going to draw thru turbocharge using a Buick 3.8 draw through turbocharger which is a T3 super 60 trim .60/.82 housings. external wastegate and custom carb plenum. I will use a '80 head that has a 1.5" exhaust valve and a 1.4" intake valve, I'm not shure on flow numbers but, the small 6 log heads don't flow well at all, combustion chambers are 62CC and I should have an 8.5:1 compression ratio, and will run 6 PSI boost normally and up to 15 PSI ( with use of boost controller ). 2.5" exhaust. oh, the bore X stroke is 3.68 x 3.126 and will run 27* of total advance. and a 600 CFM Holley 4bbl blower carb
and for a cam probably this Adv dur - 268/274 Dur @.050 - 208/218 Lift -.455/.480 Lobe center - 110* Range - 1600-5400
what # am I looking at? thanks in advance.