what will work in the heat zone? J.B.Weld do it?
Printable View
what will work in the heat zone? J.B.Weld do it?
welding is the only thing that would stay i would not use it but they make a hi heat they say can be used in a ex port moroso sell some stuff have used the A-B stuff on the intake ports but in time it will work out
And then a water hydraulic BOOM !!!
i have never had luck using chem patchers on exhaust, the only thing that can really withstand the heat is welding it
were is the hole if thru the head bolt you can run a brass liner a tube that gets push in and then broach in or if just EX gas you can weld nickel or use brazing filler rod or if it is in water you could weld or plug with i pipe plug if there is any room to drill/tap if you grinded thru then there are junk the cast may be to thin to do any thing to and make it very hard to weld
im tryying to fill the cross over ports and egr ports. and level out some other stuff in the port...
just use a gasket with out on ex cross in it you would be asking for trouble trying to fill it
yep, just gasket over it. In time, as the engine runs, the ports will fill in with carbon deposits.
yup if your manifold lacks the port then the gasket should be trouble free to block her up.......on one motor i did weld in a small piece of sheetmetal to cover the hole and then gasket over it..... worked fine but totally not neccisary