Thread: Here I am Again Part 1:2
Results 1 to 12 of 12
Threaded View
-
02-26-2009 11:49 AM #1
Here I am Again Part 1:2
Hey fellow gearheads
again, I ask for your knowledge to enlighten a dark subject.
check out cyliinder 6 rockers in the enclosed pics. this is the same motor that was bending pushrods earlier.
are the pushrods supposed to be so close to the sides of the head? do you see anything else wrong, besides the rocker and rods?
I have a few ideas of what could be causing this kind of failure, but I would like to hear what you guys have to say first.
I still wish I built this motor first... arg! this is getting annoying and very expensive!
Thanks Again
-CJPCarry On My Wayward Son
Ditto on the model kits! My best were lost when the Hobby Shop burned under suspicious circumstances....
How did you get hooked on cars?