Hybrid View
-
03-29-2004 11:36 PM #1
im looking to inject my b-block plymoth
i own a 1965 plymouth fury with a 383 b-block the motor has been rebuilt and is ready for install. what i want to do is install fuel injection and modernize the motor. can i install anelectronic ignition and fuel injection system from another car or does anyone offer a system aftermarket? anyone done something like this? is it reliable? is it easy to tune? is it worth the headache?
-
03-30-2004 06:34 AM #2
I'm sure that there are aftermarket products, and I have often heard of using chevy's RamJet system on big-blocks.
I did see a neat article in Car Craft (I believe) where they drilled holes into a regular carb intake manifold to put in injectors from a TPI system (like RamJet), then used an old carb as a throttle body. They were careful about the placement of the fuel injection rail and other parts so that you couldn't see any of them when the motor was installed, which I thought was really neat.
The key to tuning EFI is all in the computer system. You will need a computer that can comprehend the amount of fuel and air you are cramming into that big block. Most EFI systems can use the O2 sensor (something you will need to install into your exhaust system) to get the proper mix of air and fuel. Basically, the O2 sensor senses the amount of unburned oxygen in the exhaust, and then it adjusts the amount of fuel to match, so basically the big difference between carbs and EFI is that a working EFI system will automatically adjust the air/fuel ratio to compensate for real-world conditions.
If the system is put together right, it should give you a car that is more reliable and puts out more consistent power than a carb system would. The big drawback is that most people find a carb easier to work on than EFI, so if something does go wrong it can be a little more complicated to find.
Chris
-
03-30-2004 07:18 AM #3
Here's a link to a guy who did a Holley TBI on a 440; http://www.jonsteiger.com/www/barracuda/efi/
Also check http://www.indyheads.com/ they are big time Mopar guys.
I'm not doing all your research for you so I didn't look for costs on either of these, but the last two buddies of mine who did FI conversions, and did a good job of keeping track of ALL the expenses (lots of nickel dime items) were in their systems over $3K. Worth it to you?Last edited by Bob Parmenter; 03-30-2004 at 07:20 AM.
Your Uncle Bob, Senior Geezer Curmudgeon
It's much easier to promise someone a "free" ride on the wagon than to urge them to pull it.
Luck occurs when preparation and opportunity converge.
-
03-30-2004 07:35 AM #4
...Hey Uncle Bob.!!....Wouldn't it be cheaper to just inject his Mopar with a $6 can of Chevy orange.....I mean ..Ok two cans...
The cylinders have to be inline.!!!
Visited a family member at Dockery Ford from the time I was 1 year old through their ownership and then ownership change to Morristown Ford. Dockery was a major player in the Hi Performance...
How did you get hooked on cars?