Thread: rocker arms
Hybrid View
-
04-16-2005 07:18 AM #1
rocker arms
i understand that a 390 Gt and 352 4V use a 1.76 ratio rocker nonadjustable, are the numbers on them a way to identify them? I have set them up on surface plate and get about .010 difference from c/l of shaft to c/l of ball cup compared to the 1.73 rocker. Is this the only to tell them apart? I have one of each complete motors and a 66 merc 410 that i am putting the C6AE-R heads and rockers on. Thanks,,,,,,,
-
04-16-2005 09:44 AM #2
I'm not so sure about that. All the non adjustable rockers I've seen have been the 1.73 ratio and adjustables at 1.76. Any size compensation on the non adjustables was corrected with different length pushrods. It's possible one set could be aftermarket possibly. I know for a fact the Crane adjustables have a slightly different ratio than the oem and require a little long pushrod. You would think they tell you this BEFORE you get them. The oem rockers I have all use a 7 digit number. Some of the oddball ones have a 69 on them and probably might be aftermarket. I've never really gave it much thought. G.
I can't remember a singular event that triggered this nuttiness so I'll say it was being born. After we moved from Kansas to Chicago (I was 5 then) we'd drive back down each summer to visit the...
How did you get hooked on cars?