Results 1 to 5 of 5
LinkBack URL
About LinkBacksThreaded View
-
02-02-2004 10:25 AM #1
CHR Member
- Join Date
- Feb 2004
- Location
- san diego
- Car Year, Make, Model: 66 mustangFB, 69 econline Drag Van
- Posts
- 1,527
69 302 block 75 heads, pushrod problem
ok so i've got a problem with this setup... supposedly the 75 302 uses the same length pushrods as the 69 302, but... when i bought the stock 6.905 pushrods, they seem to have some up and down play when i tighten the rockers all the way down, the whole valve train is stock with hydraulic lifters and positive stop rockers. anyone know a rod that will work the geometry without paying a grip of money to have custom cut rods?
also i do have some 69 heads, but i'm not sure if they'll work, they dont have an ID # instead there is a steel plate with the letter B covering them, I've tried unscrewing them to see if there is a number below, but they wont come out even with a heavy duty makita hammer drillLast edited by thesals; 02-02-2004 at 10:28 AM.
Reply With Quote
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
I wore a camouflage T-shirt once. The response in the pub was "Oooh, it's a floating head!" .
the Official CHR joke page duel