Well in between the showers i managed to get the rear floor glassed in, I used a sheet of Bendy ply for this as the rear chassis kickup has an S shape in it and i wanted the floor to follow the shape, Bendy ply is made with the plys running the same way and this allows it to take very small radius's, you can order it to be bendy along the 8' x 4' length or sideways across.

First the shape was cut into the sheet and then the chassis was drilled and tapped 8mm, this was then bolted down with penny washers to keep it all flat.











Next the perimeter was glassed in and 1 layer put over the complete panel.








The ply only comes 8' x 4' and the body isover 4' so it was done in sections, here the rear section is in position but not glassed in as i ran out of resin










While it was pissing down i decided to make the various bits to fix the transmission cooler and 16" electric fan to the radiator, the fan brackets are made from 20mm x 5mm stainless bar, the trans cooler brackets are 16mm x 5mm stainless.