Printable View
I just built a 90 model Mrgoodwrench crate motor 350 4 bolt main SBC for my 73 Nova I used flat tops and cam was a Blueracer WG 1051 with 244/252 Duration and 516/525 lift I used a double Timing chain with 3 keyway slots I used keyway 0 I got it running well and starting just right but with a timing light the timing mark is way to the left about 3 inchs from the timing gage on the cover any ideas
Did you use the 0 line up mark on the gear as well as the 0 keyway? If not the cam to crank phasing will be "out in left field".
The timing mark relates to the crank position, the timing being that far off would indicate that your running way advanced. Is the damper the one that came on the crate engine? If it's an older damper the keyway on the damper may be positioned differently, and is giving an incorrect reading.
Good luck.:(
you could have the wrong timing tab on the engine chevy i think made 3 different timing tabs
If it runs good I agree, you might have the wrong timing pointer. Time to do the piston stop thing to find TDC and check it against the timing marks.
yep it much better to check the TDC and the damper to O on the pointer before the heads get screwed down .that bending over a car fender for old guys is for the birds trying to find TDC:DQuote:
Originally Posted by R Pope
Did the TDC and the mark is on 0 when I put the Timing chain in I use 0 keyway on the crank gear and had both marks on cam gera and crank gear pointing at each other
but did you check the damper to the pointer at TDC this has nothing to do with the chainQuote:
Originally Posted by Skipperspride
Yes the damper (ie) Ballancer mark was on about 12 % when piston reached the very top and 0 when it started back down. This has the Big Ballancer could that be the problem ballancer if it is the wrong being too big troughing everything out of wack when engin is running
when the#1 piston is at TDC the pointer needs to be at O and the damper needs to line up on O on tha tab nothing less will do the damper size has nothing to do with any thing other then gm made two tabs for them and the 8inch dampers had different key way to damper line off sets that needed different timing tabs. are you checking the timming with the vac advance hook up ? that will do it toQuote:
Originally Posted by Skipperspride
are you shure you have your timing light hooked to #1 and not #8 or#2......ted