Hi everyone,

Ok this is probably a bit off being a car hotrod board and all,

I'm a nubee to the scene of hotrodding but have been riding various different bikes over the years, and have always wanted something a bit special. So finally I've gathered up the courage and money to try and make my own hemi V8 powered bike.

Ok
#1
I know pretty much what I would like it to do stats wise but I just don't know where to begin to look for extrusions and the pieces I figured I would need would be quite specific.
Do you know any specialist extruders or do you just buy pipe and bend it?

#2
Engine wise
I'm looking at 5.2 - 6.0(5.7 rebore) litre range.
Does anyone know if mopar actually made a 5.2 litre engine though? or have any suggestions on this.

#3 This is really daft to ask but what kind of tools will I need, and is there a requirement of special training with acetylene welding.

Thanks

Iain