I'm trying to get the axle's out from the rear end, they would not just pull out so I thought that it might be a pin or bolt holding them to the gears. I dropped the drive shaft and took the bolts off the front housing and I tried to remove it and it comes out about 2--3 inches and thats it. there is a big nut on the front shaft but I think that just holds the gear on the back of the shalf or should I take that nut off. the reason I'm doing this is because the brake hubs seem like they are welded, been on there a long time, I will take the axle and put it in my press and heat it to get it off. any ideas as to how to get the yoke off the rear end-------------Richie