Hi,
I'm building a 52 Chevy for the LaCarerra PanAmericana race in Mexico. Any ideas on getting this car to handle well without changing out the front suspension? Springs, sway bars, leafs, etc..
Thanks!!!
Printable View
Hi,
I'm building a 52 Chevy for the LaCarerra PanAmericana race in Mexico. Any ideas on getting this car to handle well without changing out the front suspension? Springs, sway bars, leafs, etc..
Thanks!!!
Buy these first 4 books and start reading....
http://www.amazon.com/exec/obidos/se...279776-2947016
Thanks Richard,
I ordered the first two, should give me a good start. The problem I'm seeing here with the '52 is that is uses an upright and spindle set-up, much like a king pin with no ball-joints, and very little adjustment. I'm trying to figure out how to get more negative camber with this type of set-up.
Thanks again for the input.
Mike
it is a king pin setup actully. The pre 1953-1954 Corvette peices are supposto bolt right in, maby there are parts made for the pre '55 corvette to do what you want the suspension to do.