-
Steering Column Question
This is a follow up to my earlier question about turn signal stalks. I have the new stalk with cruise control switches, now trying to figure out how to run the wire down the column. Column is from a '79 Caprice. It has what feels like a plastic piece on the left side that the turn and tilt go through, I am trying to figure out how the heck it comes off so I can thread my new wires. I'm hoping I don't have to pull the whole column apart. There must be a way to do this in order to service a defective cruise control switch.
thanks for any help
Pat
-
Thanks Denny,
Unfortunately, there was no Cruise control wire there to begin with. It had been cut off before I got it.
Pat
-
Ouch.
That's the way I do them too Denny, Stu - that only leaves pulling it apart that I know of...Buzzard luck my friend.
-
It really looks like there is an access panel that can be removed, I will take a picture later today and post it, maybe that will trigger someone's memory or idea
Pat
-
1 Attachment(s)
Here is a picture. My finger is pointing at the piece that I believe will somehow come out of there so I could route wires down the column. The hole above my finger is for the tilt lever, the turn signal is to the right.
thanks
Pat
-
Thanks Denny, for all your suggestions and work. I'll try fishing a wire up the column as you suggest.
Pat
-
Leave it to Detroit to need 89 parts to build a steering column.