XKE jag rearend Question

Hi Guys?Gales,

This is the first time to post on this BBS...Hope I'm asking this question in the right forum.

I have a Jag XKE rearend (that I got in parts) for my T bucket project. some parts brakedowns show a spacer behind the inner bearings and seal on the hubs. What I need to know is what goes on the short shaft before you slide the hub into place...if anything???

Thanks for any help

Mark-en-"T"

Looks like no one has experience on XKE rears. You might want to try a XKE or sport car site. sorry for the no responce.
Don

if its the outer assembly jest grease the spline

If my memory serves me right, Jerry Kugel did about a zillion of these in street rods years ago. He is in California, Kugel Komponents? I think is the name of his company.
I do remember that most rodders took the rear out of its factory cage ( to see all those spinning parts ) and because of this they were a bear to adjust if not installed right. Changing the rotors would be a nightmare. I think you got to pull the half shafts to install new rotors.
Hope this helps