anyone used a goodmark full 1/4 panel or trunk pans???

I just bought a 67 gto 2 week ago all orginal, with match # motor., it will need a full right 1/4 and outer wheelhousing, and complete trunk floor. I see that for the 66-67 gm "A" bodys there is the "goodmark" trunk panel panels, and for $100 more a "made in the usa" trunk panel stamping. i was wanting to know what peoples expierence with these panels has been & and which one you would recommand? also has anyone had expierecne with the new reproduction full 1/4's how was the fit and the quaility? I would like to hear from anyone that has installed a "goodmark" full 1/4 on any car; not just a 67 gto, but if you have a new repro 1/4 on a 67 gto I would really like to hear from you

i have used goodmark 5 or 6 times on 1/4 panel and have had real good luck .

you may want to rethink using the 67 repop 1/4 they say it is not that good for this car .i have been looking at repop stuff for gto s had two of them but did not need rear 1/4 but a alot of the stuff is made by one company you and sold by many . you would be much better finding a good used one and putting it on

Some of the sheetmetal I bought from Goodmark seems a couple or maybe only a thousandths thinner than the original. It is more than adequate. I think it seems thinner because the original specs were in the King's measurements and they rounded it down for the metric. Go for it is my advice.

I've used Goodmark quarters a few times and have been very pleased. (According to my wife, that's a pretty tough job...as I'm kinda hard to please)

hey i am going by what they say about there gto 1/4?go to
the site. look at what they say???? this is the same rear 1/4 that many sell it is not that good. but it is not my car if it was i would be looking for a gm used 1/4