I'm having a problem with the doors alighning properly. They close and latch but there is a small gap where the door actually meets the body "when closed" I think when the floor was cut out to be mounted to a tube frame the inside body sort of relaxed a bit and is sagging in this problem area. I have posted a similar question a while ago but I do believe I may have figured out why and how this problem arose...I know that willys were a bit ill fitting to begin with but this is more than just slop!! How on god's green earth would I fix this? unmount the body, cut it ,re jig then re weld when it all fits good? any ideas would be great. I know that pics would be helpful but time prohibits me from this right at the moment Thank"s