Ok guys I give up. I have tried everything I can think of and still I'm stumped. So I surrender somebody has to have this answer in there bag of tricks.

I have a Lokar throttle cable. Its going on a Edelbrock Carb (rear) on a two four set-up. The stainless or insert part of this cable --( Not The Sheath ) is two long and due to the make up of the ends has to be shortened. Will the first one I cut off and then like trying to push a chain up-hill it wouldn't go back into the "Sheath" or the cable ends due to the fact that the cable itself unraveled just a small amount. The more I tried the worse it got. Now I have a tangled up mess of stainless cable that is not going into anything. On to cable two I have tried wrapping it in tape and cutting on the tape. No one can wrap tape small enough to go into that sheaf or the fitting on the cable end. I have tried JB weld and incaseing the cable letting it set and then filling and sanding to get the now encased cable into the sheaf, no go. If you get it small enough the cable unraveles.

Got to be away to do this, Maybe I'm getting in my own way here, but danged if I can figure this out. HELP!!!!

Roland