I am going to shave the door handles on my 68 firebird and was wondering what strength of solenoid I should use ? They range from 12lb up to 50lb...I want them to work but don't want my doors to blow up.:cool:
Printable View
I am going to shave the door handles on my 68 firebird and was wondering what strength of solenoid I should use ? They range from 12lb up to 50lb...I want them to work but don't want my doors to blow up.:cool:
Daily driver=50 lb
Weekend driver= 36 lb
Anything else used less than above=15-20 lb
I just put 35lb on my 60 Sedan Delivery project last week and they are border line on being to strongQuote:
Originally posted by Nassty
I am going to shave the door handles on my 68 firebird and was wondering what strength of solenoid I should use ? They range from 12lb up to 50lb...I want them to work but don't want my doors to blow up.:cool:
I put 15lb on a 74 Bronco Daily Driver about 2 years ago with no prob they still work fine
I thought the Delivery would take more but I'm going to try a set of 15's and see how they act
Hope this helps
MM64 :cool:
www.greganti.com/rambler
I'm not much on electric solenoids to open and close stuff with, but it would seem to match the solenoid to the amount of pull it takes to release the latch. How about checking it with a fish scale and see how much it takes to release the latch, then get a solenoid that meets or exceeds that amount?? Make sure you have a backup manual release so you can get in the thing if you have electrical failure or a dead battery!!!
That is exactly what I did for my 50 f1 pu it took 45 lbs to pull open so I would have to go with50lb but have yet to decide on going the shaved route. Ed ke6bnlQuote:
Originally posted by Dave Severson
I'm not much on electric solenoids to open and close stuff with, but it would seem to match the solenoid to the amount of pull it takes to release the latch. How about checking it with a fish scale and see how much it takes to release the latch, then get a solenoid that meets or exceeds that amount?? Make sure you have a backup manual release so you can get in the thing if you have electrical failure or a dead battery!!!
I do mine old-school. I don't use remotes or alarms. On my sledd, I hid the buttons behind the mounting screw for the Yankee mirrors. Push the screw, and the door pops. All it needs is a microswitch, since I use Bosch relays. The mirror is actually attached from behind now.
For solenoids, I needed a push-type that wasn't available. I used Toyota starter solenoids with a large washer and mounting bracket welded to the business-end. The washer keeps the plunger from jumping too far. Since I can adjust the end-stop, I don't need to worry about them being too powerful.