Thread: Winch connector repair
Results 1 to 4 of 4
Threaded View
-
04-05-2020 05:17 PM #1
Winch connector repair
We found a shelf casualty on the new winch we bought for the car trailer, appears the box was dropped at some point or this controller connector is just garbage.
Being a Sunday with little open to fix this, lets see what we can do.. Measurements....
Trying out some plastic fusion welding using a soldering iron... we better hide that...
Used socket as a dowel pin, hammer form plates cut out of 10 gauge steel scraps.. Our cover will be made out of polished stainless for resistance to the elements. The stainless piece is cut about 1/8 larger all around (1/4" total) so we have enough for a side lip..
Just resting here for the picture, but one "tab" was clamped in the vise, vise grips clamped the open side, and the flange hammered over. Pulled out, rotate, repeat. About 5 minutes later and we are done.
Installed...
That should hold us..
.Robert
In our neighborhood, 2 blocks down the hill was a gas station that (to me) all the cool car guys hung out there. 32 coupes, 33 & 34 Fords as well, a sweet 56 Ford Beach wagon that was setup gasser...
How did you get hooked on cars?