4 link rear

Quote:

---

Originally Posted by demano

thanks again for the advice, i will set up as close as i can, then tack well and final weld after motor and trans are also set. It seems the farther i get with this project the more questions i have but it sure is a fun and addicting adventure.

---

That's the only way to learn. Don't be afraid to ask, you might save yourself some work. Been there. :LOL:

the standard method of building rear end housings for race cars is the have the brackets main edge exactly parallel with the face surface of the housing (either where the ford 9er bolts in or the rear gasket surface on an dana or similar type housing) this gives you a surface then that you can indicate off of for measurements----------however remember that pinions aren't in the middle of the housing so be careful with the side to side location of where you mount them.