Thread: carburetor size

Tweet

Has any of you guys used AED Carbs. www.aedperformance.com. on your street rods. I'm looking for a good carburetor for my mud drag pickup. The motor is a 454 with about 450 hp-500tq. They want to sell me a 750 ho carb that flows about 800 cfm supposedly. 500 dollars. I was wondering what you guys like to run on your big blocks.

HI sawking I use Holleys not to complecated and easy to work on currently have 4150 pro series 750 double pumper it's fine to use to get my car running but to small for my cam and MODS I have donefor 1/4 and 1/8th mile.had this carb on 10.00sec nova and at around the 3000 foot mark the car would stop pullin with same cam,found out that when go with a big cam like this engine do's not make enough Vacume to operate vacume secondarys properly so when car is ready for test and tune it will get a Holley 4500 series 1050 or1150 if I change to BRODEX heads.

all most 20 years 9377 holley 1150 for power but for some thing mild edelbrock work good and have had very good luck with them on blowers to i would thing that 800 cfms will get the job done for you

Thanks for the reply guys. I'm going to get the 750ho I let you guys know how it goes.

HAy SAWKING, If your truck will see any street driving might want to go with a carb that has Vacum Secondarys be a little better on Gas.If full on drag truck go with a Mechanical- Secondary carb. Hay I just made a Funny like your Gas milage is for Crap to begain with. 450 to500 HP ,you probably run 44" super swampers 4:11's front and Back Gear good luck Man.we run Sunowco 110 octane at $5.00 a gallon in a 5 gallon fuel cell,get 3 passes befor toping off.Any way just some food for thought on the Carb thing. Remember;IT'S BETTER TO BURN OUT THAN TO FADE AWAY!BBL-CHEVY ALL THE WAY.

I have an 825 Barry grant Mighty demon, best carb i have ever owned. i will let you know how well it works on my new 468 once i get it on the dyno.

Do you guys think that a mighty demon will perform better than a holley. I never used a mighty demon but I have heard a lot of good things about them.

i have seen alot of them can not say much on them. i do not use them

i had a 750 mighty demon carb was the best carb i ever owned. i just bought a street strip vehicle from around here it has a 950 proform doing a lil jet work right now wish i had my old demon though

Originally Posted by sawking

Has any of you guys used AED Carbs. www.aedperformance.com. on your street rods. I'm looking for a good carburetor for my mud drag pickup. The motor is a 454 with about 450 hp-500tq. They want to sell me a 750 ho carb that flows about 800 cfm supposedly. 500 dollars. I was wondering what you guys like to run on your big blocks.

I run a 750 on a 396 with no problems..But it does have the hottest street cam I could find with big headers....