Thread: Getting into the 12's
Threaded View
-
08-05-2006 10:20 PM #19
run them all the time at 002.5 on the rods to003+ on hi whinders on the mains 0.003 to 0.003.3 is ok you may see more on the rear main #5 this is ok but for a stock driver i would like to see the mains a bit smaller with a stock pump but this is not so you will be fine on the ring yes open them up .022 +or so cut the ring with the QT plate on the deck if it was honed this way you do not want them to butt and i hope you added at least .001 more on the big side of the piston to wall you do not want them to tight. the rods would be be nice to see abit more0.003 you could lap them with wet dry 320 on a very flat surfaceLast edited by pat mccarthy; 08-05-2006 at 10:37 PM.
Irish Diplomacy ..the ability to tell someone to go to Hell ,,So that they will look forward to to the trip
I wore a camouflage T-shirt once. The response in the pub was "Oooh, it's a floating head!" .
the Official CHR joke page duel