Thread: Intake....Head Question

Tweet

In the center of the heads.........I guess you have the exhaust cross over that the intake or gasket doesn't cover. Anyway to fill this area in with something or let it be????????

Thanks for any suggestions

if the intake is closed or weld the cross over in the intake then thats all you have to do filling the head s is some work and you will not see much from the work.were you see any thing is keeping the heat out of the intake

The intake is closed........Just don't like seeing the hole with intake on.

Originally Posted by pat mccarthy

if the intake is closed or weld the cross over in the intake then thats all you have to do filling the head s is some work and you will not see much from the work.were you see any thing is keeping the heat out of the intake

Originally Posted by 198plus

The intake is closed........Just don't like seeing the hole with intake on.

when the intake is on it will close the cross over port s ex gas.it can not go up if its block by the intake

close your eyes when you put the intake on

The intake doesn't cover it ?????

Pic...........

Originally Posted by pat mccarthy

close your eyes when you put the intake on

Originally Posted by 198plus

The intake doesn't cover it ?????

Pic...........

your gasket should cover it use a mr gasket or a stock gasket should as well that is not the port that part go s a round the port and is more like a shield keeping oil off the hot ex port will not hurt any thing it dead heads in to the head so no ex runs thru that part

Thanks, Pat