Thread: Single plane

Tweet

I got my 489 almost done but I need a single plane intake with square flange low profile so I can keep my stock hood anyone got any ideals I've look everywhere

I don't think you'll find a low single plane manifold

I don't know why anyone would build a nice, stout 489 and then choke it off with the wrong intake manifold. Take the hood off, sling it over the fence and install a tall intake like the motor wants.

.

Originally Posted by techinspector1

I don't know why anyone would build a nice, stout 489 and then choke it off with the wrong intake manifold. Take the hood off, sling it over the fence and install a tall intake like the motor wants.

..... or maybe not QUITE so extreme, start shopping for a nicely styled hood scoop that compliments the line of the car.

Man I hate to mess my hood up.

What are you building? Put the stock hood in the rafters and get a 'glass one that will give some carb clearance....
Mark

Man I got a to much in this 68 chevelle 2 times what it's worth but $15000 grand just in motor still need a 950 quick fuel , and set headers , intake , and Torque convertor , now a hood and paint , I hope the trans will hold up its a 400 and hope the 12 bolt will hold up. It had a good 396 in it ,, I hope this stroker motor is a good one, should be a lot stronger

$15000 in motor minus carb, intake, exhaust??????????? You been drinking too much moonshine?

That is aircondition too

Have you looked at drop base air cleaners??? they work pretty good on the holley type carbs that don't have choke towers when used with the K&N extreme top plate.
Does your heads have raised exhaust ports???? If so you will need special headers

All it takes is money bud... One thing leads to another and you are finding this out real quick.
Mark

You'll make more power under curve with a dual-plane, high-rise manifold than you will with a single plane from 1500 to 6000.
Edelbrock 7161 or Weiand 8019 for oval ports, Edelbrock 7163 or Weiand 8018 for rectangular ports.
If the motor will be operated only above 6000, use a single plane intake for additional power.

.

Wow Denny great article, very interesting what a spacer did on the dual planes, might need to add one of those to the 460!

I had a 396 in it with a rpm air gap intake and the hood would barley close, I wanted a dual plane but my engine builder says it's all about moving air he said a dual plane will cost me 50 hp ?, and I don't know , it has afr heads square ports , it's going to be. Street car on pump gas

I see the light------------