Thread: question for techinspectro1 or anyone else

Tweet

What would you suggest for ideal setup for solid 350-400hp on 350 sb. Realistic without spending a lot of money, even though I realize its not cheap to build engine up. Thanks for your help!

Bore 0.030"
Keith Black #KB193 pistons (12 cc dish)
Cut block decks to pop pistons out of bore 0.006" at TDC
Fel-Pro #1003 head gaskets
Scoggin-Dickey #SD8060AGP L31 Vortec heads with valves and 0.525" lift springs installed. Machined for screw-in studs and guide plates (guide plates and studs not included) $356.47 each.
Order online www.sdpc2000.com
Tech line phone 1-806-798-4108
Edelbrock Performer RPM Air Gap Vortec intake #7516
Edelbrock AVS 650 carb #1805
Call your favorite cam grinder for a recommendation. I'd be thinking something like this for decent manifold vacuum.
http://www.cranecams.com/?show=brows...tType=camshaft
2,500 stall converter
1 5/8" headers

I have no way to nail down the horsepower or torque this motor would make. I just think it would make a good street motor. (9.55:1 c.r. to run on pump gas with the squish)