ok well I finally get my 350 4bolt tomorrow.. it is a bare block from a 2002 van.. and my idea with this motor is either to build a twin turbo setup or a Roots supercharger motor..

I will obviously be starting from block up so my first step after gettign the block is to hone out the cylinders (suposidly the motor has like 15,000 miles on it and it was pulled due to a bolt being dropped in the motor and they pulled it and warantied it (shop truck, never started after the bolt was lost)

anywho I figure since the cylinders are nice I would hone the block (just to clean it up) then move onot the crank, bearings, rods and pistons.. or am I forgeting something first??

since I want to run a boosted motor what crank rods and pistons do u guys recomend.. I obviously will need deep dished pistons (for lowering compression) but I dont know what I shoudl look for in a crank and rods... what brank, forged or not, what specs etc..

I am a once beloved ricer turbo guy and now I have turned over to the dark side lol

I just want to do it right and have fun with it..

any and all info u can give me would be MORE then appreciated..

thx in advance

Dave