Thread: Do I have the correct gaskets?

Tweet

Picked up a set of Mr. Gasket ultra-seal intake gaskets today. I noticed that the gaskets are solid where the smaller center ports are located. Only have the bolts holes there. Will these work?

The packaging states for 1987-1995 Gen I SBC.

Application heads:

14101083...1987-up...350..........Gen.I, also used on crate motors, 285 or 300 hp, 64cc chambers, 72' center manifold bolt angles. (Mortec.com)

Hope someone can help with this.

The attachment is a diagram of the suspect area..

Originally Posted by DennyW

If you do not want heat to go to the intake, these will work.

Thanks Denny,
Will the electric choke on the Edelbrock(1406) still function as it should? Does the choke need this heat? I could cut out the area if need be. Would rather install as they are if I can.

I am curious, would blocking these have any performance advantages?

Thanks for helping out Denny.