Thread: need some engine advise....
Results 1 to 4 of 4
LinkBack URL
About LinkBacks-
08-15-2007 09:09 AM #1
CHR Member
- Join Date
- Nov 2003
- Location
- peterborough
- Car Year, Make, Model: 1956 pontiac pathfinder
- Posts
- 127
need some engine advise....
i currently have a sbc 350 thats freshly bored .040 over with double bump heads 1.94 1.60 that have been done all new springs crane chrome moly full roler rockers, speed pro flat top 2 valve relief hyper techs with the teflon coating, holley strip dominator intake with a holley 600cfm vaccum secondary cam specas http://www.cranecams.com/?show=brows...tType=camshaft
its got 4.10 gears and a nv3500 trans mission its got 250 psi across the bored with an X pipe it just seems kinda weak and i was wondering if that was the best cam choice???
-
Advertising
- Google Adsense
- REGISTERED USERS DO NOT SEE THIS AD
-
08-15-2007 09:20 AM #2
CHR Member
- Join Date
- Mar 2007
- Location
- Mesa
- Posts
- 1,385
Gonna start with a basic question, did you just "slap" the cam in or put a degree wheel on it to make it right?What if the "Hokey Pokey" is what it's really all about? 
-
08-15-2007 11:37 AM #3
CHR Member
- Join Date
- Oct 2002
- Location
- Vicksburg
- Car Year, Make, Model: 37 Ford 2dr. Sedan
- Posts
- 197
are you sure the valves are adjusted properly?Andy
My project build video:
http://www.youtube.com/watch?v=iubRRojY9qM
-
08-15-2007 03:06 PM #4
CHR Member
- Join Date
- Nov 2003
- Location
- peterborough
- Car Year, Make, Model: 1956 pontiac pathfinder
- Posts
- 127
[QUOTE=DennyW] relieve the exhaust side of the ports,QUOTE]
what do you mean by that ya lost me??
Reply With Quote
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
Great to see your new post, Mike, and great to see CHR up and running again after several days of the Hmmm, can't reach this page.... Also good that you found an easy solution to your storage/access...
1968 Plymouth Valiant 1st Gen HEMI