Thread: 350 cutting out??????
-
10-15-2008 09:47 AM #1
350 cutting out??????
hello i have a 1985 gmc 4x4 that has a crate motor in it.It ran fine and the starter went out so i put it in a demo car. I ran the car in one heat and the distributor cap broke so i was done. I put a new cap and rotor in it and it ran fine in the car so i put back in the truck. I drove the truck a few days with a little cutting out but now you drive it and it will die when u give it gas. It will idle fine but sounds like there is a air leak inside the carb.just wondering if anyone has had this problem. Thanks for the help.
-
Advertising
- Google Adsense
- REGISTERED USERS DO NOT SEE THIS AD
-
10-15-2008 12:06 PM #2
First I would check the fuel filter. Then the ignition modual inside the cap.It is HEI corect?? You will just have to do this by elimination till you get it right GOOD LUCKCharlie
Lovin' what I do and doing what I love
Some guys can fix broken NO ONE can fix STUPID
W8AMR
http://fishertrains94.webs.com/
Christian in training
-
10-15-2008 12:21 PM #3
ok thanks for the advice ill keep you posted on how it goes and it is the HEI.
-
10-15-2008 03:04 PM #4
no fuel flow. You're only getting enough to idle..
Education is expensive. Keep that in mind, and you'll never be terribly upset when a project goes awry.
EG
Great to see your new post, Mike, and great to see CHR up and running again after several days of the Hmmm, can't reach this page.... Also good that you found an easy solution to your storage/access...
1968 Plymouth Valiant 1st Gen HEMI