Thread: 350 overheats
-
10-16-2008 11:51 AM #1
350 overheats
i just built a new motor for my truck. started it up and ran great. then it overheated.
timing seems ok. no flow through the radiator. top radiator hose gets hot and pressureizes but bottom stay cool. brand new 180 thermostat from napa installed spring down. i assume it opens cause the top radiator hose is hot. pulled the thermostate out and doesent overheat of course but runs to cold.
thanks cody
-
Advertising
- Google Adsense
- REGISTERED USERS DO NOT SEE THIS AD
-
10-16-2008 12:59 PM #2
Sounds like a bad thermostat.
-
10-16-2008 01:28 PM #3
Cody, test the thermostat in a pan of water on the kitchen stove, you'll know for sure if it opens/closes.
Mike
-
10-16-2008 01:48 PM #4
If the thermostat looks good start looking at the water pump.
Is it old...new? Standard or reverse rotation? What type drive system...standard belts or serpentine?Our race team page
Chuck
-
10-16-2008 04:58 PM #5
friend of mine put a serpentine drive on his chevelle. Unfortunately for him the serpentine kit did not come with a reverse flow fan. ( serpentine reverses the fan direction ) Ran hot, and took him a while to figure it out..
Education is expensive. Keep that in mind, and you'll never be terribly upset when a project goes awry.
EG
-
10-16-2008 05:25 PM #6
Wrong rotation water pump.
Ok gang. It's been awhile. With everything that was going on taking care of my mom's affairs and making a few needed mods to the Healey, it was June before anything really got rolling on this...
My Little Red Muscle Truck