Thanks for the info!

I believe my motor is a Gen III LM7. I also believe the flow is the same as the LS1 and newer. I also believe the LS1 and newer all have the steam vent coming off the top of the motor.

Is this correct?

My real questions is where / how to connect the steam hose from the motor to my system? I am considering welding a vent into my radiator just below the radiator cap. That way steam from the motor should vent out to the overflow tank from the radiator cap vent. Any thoughts would be appreciated.

My other issue is that the "hot" water hose coming from the motor goes over my shroud to the top left of the radiator. This hose is now about 1 inch above the level of the radiator cap. Will this result in me not being able to fill the radiator or will any air in the system be forced out the radiator cap vent and be replaced with flud from the overflow tank? Will this "burp" itself or do I need to vent the air somehow? Any advice would be appreciated.

Thanks