im talking it was all coated in raw oil and a little unburnt gas. it was leaving puddles out of the drivers tail pipe. it is tru dual all the exhaust was brand new


we tore it down valve seals were bad replaced them, check the rings on the cylinder's they were stuck but not busted unstuck them checked them really good reinstalled, while it was down found out the cam was trashed and replaced that too didnt notice any place on the head gaskets where it could have been leaking but the drivers side came off in a few different pieces the passenger came off like it was new.

engine work is complete and ill finish installing the heads and finding out if i solved the issue or not tomorrow. but we didnt find any definite source of the oil.


im not a glass half full person. im crossing my fingers and hoping we got it. but since im not sure i thought id ask so the advice was here in case we didnt find the problem.

not new to engine's and my father isnt either between the two of us theres over 45 years experience here. neither of us has seen this amount of oil out of a tail pipe before.


where are all the possible places all that oil came from?