The truck is not lifted, but thats not saying it never has been.
If I put the crossmember inside frame then bolt holes wouldn't line up. On the crossmember, there are two holes on the raised part and 2 holes (further apart) on the outside part. The set of holes further apart, there is no bolt holes that match on the frame. If I were to put that crossmember inside the frame, I'd either have to turn it upside down so the bolt holes match, or there would be about a 2 inch difference between where the bolt went through the crossmember until it gets to the frame.

There has to be pictures of this on the internet somewhere, I just dont know where to look for them.