Thread: Rebuilt SBC Smoke
Results 1 to 3 of 3
LinkBack URL
About LinkBacks-
09-03-2012 11:47 AM #1
CHR Member
- Join Date
- Jun 2011
- Location
- st. anthony
- Posts
- 8
Rebuilt SBC Smoke
I just had my 350 sbc rebuilt and put in my car. It was a total rebuild including the heads. On the first start up it had hardly any smoke and ran fine. The only problem is when I give it hard acceleration it starts to smoke really bad, and wont stop. After letting it sit for about a day i went and started it and it hardly smoked so i took it for a drive and it started doing the same thing again! What could it be?
-
Advertising
- Google Adsense
- REGISTERED USERS DO NOT SEE THIS AD
-
09-03-2012 11:58 AM #2
CHR Member
- Join Date
- Aug 2003
- Location
- CC
- Car Year, Make, Model: 70 Camaro Z-28 Now/40 Chevy Back Then
- Posts
- 4,306
Did they do anything to the valve guides?
Could be hard acceleration on new unseated rings is not a good idea.
PCV valve stuck?
Intake gaskets not sealing?"PLAN" your life like you will live to 120.
"LIVE" your life like you could die tomorrow.
John 3:16
>>>>>>
-
09-10-2012 08:11 PM #3
CHR Member
- Join Date
- Jun 2011
- Location
- st. anthony
- Posts
- 8
The valve guides were replaced when rebuilt. Im going to check out the intake gasket and the PCV tomorrow and ill see what happens!
Reply With Quote
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
Thank you Roger. .
Another little bird