19LikesThread: 350 sbc build need advise
Results 1 to 15 of 24
LinkBack URL
About LinkBacksThreaded View
-
03-17-2019 04:03 PM #22
CHR Member
- Join Date
- May 2003
- Location
- Zephyrhills, Florida, USA
- Car Year, Make, Model: '32 Henway
- Posts
- 12,423
Wiseco #KP456A4 4.040" pistons w/12cc dish to be used with 6.000" connecting rod, including rings. Piston compression height (centerline of wrist pin to crown), 1.275".
Scat 6.000" connecting rods.
Using Fel-Pro 1003 gaskets with 64cc combustion chamber and zero decks, static compression ratio will be 10.25:1. Use Pro-Filer heads with 210cc intake runners for killer power to 6000.
Use 850 CFM carb on tall dual-plane intake. If your air gap does not make the motor buck and snort in cool or cold weather, use it. Otherwise, use a Weiand 8150.
Order the whole mess balanced.
Use a 2-piece front cover to make fitting the thrust button or changing or phasing cams easy.
https://www.summitracing.com/parts/c...make/chevrolet
I like a nylon thrust button because it's not necessary to tear the motor down and clean out all the shrapnel when a roller bearing thrust button frags.
.
https://www.summitracing.com/parts/cca-202/overview/Last edited by techinspector1; 03-18-2019 at 03:37 AM.
PLANET EARTH, INSANE ASYLUM FOR THE UNIVERSE.
Reply With Quote
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
The first model car I built was a 32 Ford roadster by Revell in the mid 50's.
How did you get hooked on cars?