Thread: Crane Cams stud girdles.
-
07-13-2004 03:42 PM #1
Crane Cams stud girdles.
Ok,long story short.Sat I bent my rocker studs at the track.
So I went to the shop and grabbed a set of Crane studs and Girdles. I stared to install them today.Got the right side done.Now my valve cover wont clear. There a set of Edelbrock signature series Tall profile. Thay seem to be hitting on the inside bafflies. Can I remove the bafflies?? Thay look as if there only tack welded on. I figger a flat head screwdriver should pop them off.
-
Advertising
- Google Adsense
- REGISTERED USERS DO NOT SEE THIS AD
-
07-13-2004 03:49 PM #2
Hmmmmmmmmmmm, a very BAFFELING question.
Go ahead and knock em out unless your using a pcv valve in one of the holes.
-
07-14-2004 05:37 PM #3
Done and done.Knocked them right out,and now thay fit. Thanks guys ..
-
07-14-2004 05:45 PM #4
OHHH MAN I JUST FOUND OUY YA CAN"T DO THAT !!!!!!!!!!!!
just kiddin(he-he)
Thanks guys! One more trip around the sun completed. Lots of blessings and things to be thankful for (like still being able to type this message!!) Here's to us "over 70 guys.." Glenn
HBD Glenn!!