945LikesThread: Another Build Thread - My '32
Results 1 to 15 of 532
LinkBack URL
About LinkBacksThreaded View
-
07-23-2019 12:40 PM #11
CHR Member
- Join Date
- Jul 2003
- Location
- Titusville, FL
- Car Year, Make, Model: 31 Ford Coupe; 32 Ford 3-window
- Posts
- 1,791
To fabricate the straps I used 1/8 x 1 flat steel. Using a tailor's fabric measuring tape, I measured the length of the straps I needed (24 inches) and also where the bends would need to be (13 and 22 inches). I made the bend for the bottom angle about 1/4 inch above the floor (21 3/4). This will make the strap very tight when it is bolted down at final assembly.
For now everything is just lightly snugged; I used a large fender washer under the floor. I may tack-weld the nut to the washer later and stick it in place with a dab of body filler. That way I can assemble it without "extra hands".
Also, when I assemble the car for the final time I will line the supports and straps with rubber.
Jim
Racing! - Because football, basketball, baseball, and golf require only ONE BALL!
Reply With Quote
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
Sorry for your loss of friend Mike McGee, Shine. Great trans men are few and far between, it seems. Sadly, Mike Frade was only 66 and had been talking about retirement for ten years that I know...
We Lost a Good One