Another Build Thread - My '32

[J. Robinson]

Sorry for the slow answer - been on other tasks for the last couple weeks... It's pretty solid, made from .060" thick aluminum so it doesn't need any 'glass for strength. I will probably just seal the edges with some epoxy before I put the Kilmat insulation over it.

As I said, I've been doing a dozen other things (mostly "Honey-do's"), so I haven't spent much time in the shop. One thing I did accomplish was making patterns for my under-dash panel and a small console. Ignore the battery sitting on the floor; it's just there to run the power seats while I'm fitting things. The air conditioner evaporator unit will protrude through the center of the panel right under the dash. Below that, in the vertical part of the console, I can put a radio. The bottom console will have two cup-holders. If there is room I will put a small glove compartment in the far right side of the under-dash panel.