Thread: Dragster Blueprints

Tweet

I want to build a rear engine dragster. Anyone have a blueprint they would like to share? I would consider a front engine but would prefer a rear. If anyone has anything please contact me.

Jason
choperules@yahoo.com

Check out racingjunk.com. Usually any number of them listed for less then you could build one for...they have to be certified, too...

Originally Posted by choperules

I want to build a rear engine dragster. Anyone have a blueprint they would like to share? I would consider a front engine but would prefer a rear. If anyone has anything please contact me.

Jason
choperules@yahoo.com

You are better off but one pre-built.
I have been down the same road about 15 years ago.
Just try going through tech.
At the time we built our "rail" I was boiler certified in welding.
The NHRA techs. did'nt like the fact our rail was homemade and tried his damnest to find fault with it.
After over two hours of this B.S. with the NHRA techs. we finally got a chance to run the car.

have just finished a ft eng dragster, passed tech 1st time to 7.50. morrison has plans , get them, a nhra rule book, and the sfi specs. The best deal is buy one running, or roller. a friend sold his 4 yr old back motor, complete and the guy stoped off at a track on the way home and won 2 k. you can buy used cheaper than build. try racing junk. com. lots of bargains.

Well since everyone else tried to talk you out of it I'll answer your original question.

Try Mark Williams. I got my first set of T/A and TA/FC prints from them twenty years ago. Their solid FC and digger prints havent changed much and I think they still sell them.