I took everyones advice,took the pan off, cleaned it and the sump after breaking in the cam I pulled the valve covers off .everythings working ok. The pushrods are rotating I could feel them turn. I poured in a can of engine flush and changed the oil and filter three times. the last time I added a quart of lucas. The timing is set at 16 btdc and 34 total. The engine idles at 1200 with 14 inches of vacuum in park drops to 900 in gear it has more oil pressure than it had for a long time. She runs real smooth too! I think the motor likes this cam better bigger isnt always better! Its a crane also with 224 234 dur 465 480 lift. I took her out and hit it one time she burnt the tires went a little side ways and was gone! Im glad I found HOT ROD FORUM and every one who answered my questions and gave there advice THANK YOU ALL youll be hearing more from me thanks again Debbie DRIVE IT LIKE YOU STOLE IT